Rubber Roofing

Installing Firestone EPDM rubber roofing involves several steps. Here’s a general guide to help you get started:

Surface Preparation:

• Ensure the roof surface is clean, dry, and free from debris.
• Remove any existing roofing material or damaged sections.
• Repair any structural issues or leaks.

Measure and Cut EPDM Membrane:

• Measure the roof dimensions accurately.
• Cut the Firestone EPDM membrane to fit the roof size, leaving some overhang for edges and corners.

Apply Adhesive:

• Apply contact adhesive to both the roof deck and the underside of the EPDM membrane.
• Allow the adhesive to become tacky (follow manufacturer’s instructions).

Lay the Membrane:

• Carefully position the EPDM membrane on the roof.
• Start from one edge and work your way across, ensuring proper alignment.
• Smooth out any wrinkles or bubbles.

Seam Sealing:

• Use seam tape to join overlapping sections of EPDM membrane.
• Apply seam primer to the seams and let it dry.
• Apply seam tape over the seams, ensuring a tight seal.

Detailing and Flashing:

• Install flashing around roof penetrations (vents, chimneys, etc.).
• Use EPDM patches and adhesive to seal corners, edges, and other details.

Trim Excess Material:

• Trim any excess EPDM membrane using a sharp knife.
• Leave a slight overhang at the edges for proper water drainage.

Secure Edges and Corners:

• Use edging trims  to secure the EPDM membrane along the edges.
• Seal corners with corner patches and adhesive.

Inspect and Test:

• Inspect the entire installation for any loose areas, wrinkles, or gaps.
• Perform a water test to check for leaks.

Maintenance:

• Regularly inspect the EPDM roof for damage or wear.
• Keep the surface clean and free from debris.

If you need further assistance, consult a professional roofer or refer to installation videos available online. Good luck with your EPDM roofing project!